The status of relay is indicated by the RED Led.Design and Operation:-
When an electric current is passed through the coil it generates a magnetic field that activates the armature and the consequent movement of the movable contact either makes or breaks (depending upon construction) a connection with a fixed contact. If the set of contacts was closed when the relay was de-energized, then the movement opens the contacts and breaks the connection, and vice versa if the contacts were open. When the current to the coil is switched off, the armature is returned by a force, approximately half as strong as the magnetic force, to its relaxed position. Usually this force is provided by a spring, but gravity is also used commonly in industrial motor starters. Most relays are manufactured to operate quickly. In a low-voltage application this reduces noise; in a high voltage or current application it reduces arcing.
When the coil is energized with direct current, a diode is often placed across the coil to dissipate the energy from the collapsing magnetic field at deactivation, which would otherwise generate a voltage spike dangerous to semiconductor circuit components. Some automotive relays include a diode inside the relay case. Alternatively, a contact protection network consisting of a capacitor and resistor in series (snubber circuit) may absorb the surge. If the coil is designed to be energized with alternating (AC), a small copper "shading ring" can be crimped to the end of the solenoid, creating a small out-of-phase current which increases the minimum pull on the armature during the AC cycle.
Relay can control any devices just like a switch contact. Its contact is isolated from the driven circuit.
LED Indication of Relay ON.
Power Indication LED.
ULN2803 Relay Driving IC.
ON/OFF Power Switch.
Direct input from 3-5V Microcontroller for relay control.
Output terminal for relay contacts.
Provision of male header for wire connection.
Powered from external 12V or from male header.
5A at 240V AC
It is important that microcontroller share ground with relay board along with other control signals else it will not able to control relay.