1-CH 12V Relay Board

SKU
RC_R1293
In stock
Special Price Rs 108.56 Rs 92.00 was Rs 217.12
  • A relay is an electrically operated switch.
  • Current flowing through the coil of the relay creates a magnetic field which attracts a lever and changes the switch contacts.
  • The coil current can be on or off so relays have two switch positions.
  • The RM1036 have double pole, double throw(changeover)switch contacts.
  • Relays are used where it is necessary to control a circuit by a low-power signal (with complete electrical isolation between control and controlled circuits), or where several circuits must be controlled by one signal.
  • -
    +
    Design and Operation:- When an electric current is passed through the coil it generates a magnetic field that activates the armature and the consequent movement of the movable contact either makes or breaks (depending upon construction) a connection with a fixed contact. If the set of contacts was closed when the relay was de-energized, then the movement opens the contacts and breaks the connection, and vice versa if the contacts were open. When the current to the coil is switched off, the armature is returned by a force, approximately half as strong as the magnetic force, to its relaxed position. Usually this force is provided by a spring, but gravity is also used commonly in industrial motor starters. Most relays are manufactured to operate quickly. In a low-voltage application this reduces noise; in a high voltage or current application it reduces arcing. When the coil is energized with direct current, a diode is often placed across the coil to dissipate the energy from the collapsing magnetic field at deactivation, which would otherwise generate a voltage spike dangerous to semiconductor circuit components. Some automotive relays include a diode inside the relay case. Alternatively, a contact protection network consisting of a capacitor and resistor in series (snubber circuit) may absorb the surge. If the coil is designed to be energized with alternating (AC), a small copper "shading ring" can be crimped to the end of the solenoid, creating a small out-of-phase current which increases the minimum pull on the armature during the AC cycle. Relay can control any devices just like a switch contact. Its contact is isolated from the driven circuit. Features: LED Indication of Relay ON. Direct input from 3-5V Microcontroller for relay control. Output terminal for relay contacts. Provision of 2x3Pin male header for wire connection. Powered from external 12V or from male header. Contact Rating: 5A at 240V AC Note: It is important that microcontroller share ground with relay board along with other control signals else it will not able to control relay.
    More Information
    Bestseller No
    Is Featured No
    rpi No
    HOT DEALS No
    Write Your Own Review
    You're reviewing:1-CH 12V Relay Board
    Your Rating
    We found other products you might like!

    Shipping

    All Over India

    Accept payments online

    Genuine Products

    Safe Transactions

    Same Day Shipping

    0 / 5
    Contact Us