SD Card Module
Out of stock
Special Price Rs 214.76 Rs 182.00 was Rs 322.14
The level conversion circuit board that can interface level is 5V or 3.3V support micro SD card, micro SDHC card (high-speed card) Power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board Communication interface is a standard SPI interface 4 M2 screw positioning holes for easy installation Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin Level Conversion Circuit: Micro SD card into the direction of signals into 3.3V, microSD card toward the direction of the control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is SPI bus, CS is the chip select signal pin
The module (MicroSD Card Adapter) is a Micro SD card reader module and the SPI interface via the file system driver, microcontroller system to complete the Micro SD card read and write files. Users can directly use the Arduino IDE comes with an SD card to complete the library card initialization and read-write. . 3.3V voltage regulator circuit: LDO regulator output is 3.3V level converter chip, Micro SD card supply. Level conversion circuit: Micro SD card into the direction of the signal is converted to 3.3V, MicroSD card interfaces to control the direction of the MISO signal is also converted into 3.3V, general AVR microcontroller system can read the signal , . Micro SD card connector: a self: bomb deck, easy card insertion. Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter: module combination ,
Write Your Own Review
We found other products you might like!
- Jumper Wires Male to Male, male to female, female to female, 120 PiecesSpecial Price Rs 271.40 Rs 230.00 was Rs 407.10