A 300 RPM, single shaft Rectangular DC geared motor. It is most suitable for lightweight robot requiring small power. This motor can be used with 69mm Diameter Wheel for Plastic Gear Motors and 87mm Diameter Multipurpose Wheel for Plastic Gear Motors.
Drive shaft has a clutch for non-continuous protection from overload which protects gears from the sudden overload. Motor runs smoothly from 2V to 12V and gives a wide range of RPM, and torque. The table below gives a fairly good idea of the motor’s performance in terms of RPM, no load current as a function of voltage and stall torque, stall current as a function of voltage.
1. Less load-carrying capacity, due to lower maximum allowable stress; the greater compliance of plastic gears may also produce stress concentrations.
2. Plastic gears cannot generally be molded to the same accuracy as high-precision machined metal gears.
3. Plastic gears are subject to greater dimensional instabilities, due to their larger coefficient of thermal expansion and moisture absorption.
4. Reduced ability to operate at elevated temperatures; as an approximate figure, the operation is limited to less than 120°C. Also, limited cold temperature operations.
5. Initial high mold cost in developing correct tooth form and dimensions.
6. Can be negatively affected by certain chemicals and even some lubricants.
7. Improper molding tools and the process can produce residual internal stresses at the tooth roots, resulting in overstressing and/or distortion with aging.
8. Costs of plastics track petrochemical pricing and thus are more volatile and subject to increases in comparison to metals.